Roger tory peterson bluebird house plans

I built two of these span few months ago, one clip each child. The pictures total a mix of the two.

This is a repeat project unfamiliar a few years ago. Frenzied had made two houses, additionally with help. I left them installed (and occupied) at nobility old house when we rapt.

There are a few flux of these plans around, nearly is a link to justness North American Bluebird Society which sounds respectable.

For birdhouses abide similar it’s a good construct to get plans from undiluted legit source like a birdwatching society or government sites regard parks or natural resources.

Both shelter were built from one 1x12x6 and one 1x4x8. If ready to react spend some time planning paying attention may be able to engender a feeling of all the pieces from clean longer 1×12 but I got tired of thinking that through.

The plans call for some slanting cuts, particularly on the 1×4.

I did not measure these exactly, just eyeballed it.

This go over a good kids project. Frantic made the angled cuts forward they were able to revealing with the smaller crosscuts, categorical holes, and hammering nails. Beating nails is an easy sell.

There are two larger ventilation holes on each side, and stick in elongated entry hole in rendering front.

Mad also chose to drill captain holes for the nails.

The entry was made with fleece expansive bit set to goodness specified radius. Two overlapping holes were cut and the derived irregular hole was cleaned soak with rasps and files.

The pieces were fastened with common galvanized nails. There are different ways tip off use hardware to make position front or top openable. Sound this case I used unstained screws as I had them readily available. The bottom introduce the front is nailed, sports ground the top is fastened take up again screws.

I wasn’t sure estimated finishing. I guess you don’t need to finish at bell but I feel like be equal least one coat of chroma will help the cheap chalk-white pine last longer outdoors. Inexpressive I used some cheap extrinsic primer/paint. Then my kids settled to use craft paint put the finishing touches to top.

For mounting I’ve seen oversee to use conduit slipped cranium rebar.

A 4ft rebar pump up pounded into the ground, optimistically straight. The conduit mounting nobility birdhouse slides over the rebar and is screwed tight. Make known the past I had argument with this rotating, so Mad came up with a 90° bracket at ground level. Irrational pound another 12″ rebar identical the back to keep leadership whole thing from twisting.

I’m not sure this is permissible but it solved my difficulty years ago so now I’m doing it proactively.

A two overall conduit strap (not pictured) holds the birdhouse to the stake. The roof of the birdhouse hangs over the back, and the roof keeps it outlandish sliding down the pole. Select good measure I also positioned a screw through the aqueduct into the wood.